Transmitting; Receiving; Lcd Mode Display Selection; Channel Selection - Dynascan V-440 Manual De Instrucciones

6.6.- TRANSMITTING:

Press [MONI] key to check and confirm that the channel you selected is available.
Press [PTT] key to talk.
1.- Keep your mouth away from the microphone 3 cm - 5 cm, and talk with a normal voice.
2.- Press [PTT] key and the LED status indicator will light red.
3.- Release [PTT] key to receive.

6.7.- RECEIVING:

When you receive a communication, the LED status indicator will light green.
If you set the squelch sensitivity level with a low level and a weak signal, you may not receive the
communication. When the transceiver has been set to encode the signal with CTCSS or DCS, you
will only able to receive signals with the same encode settings.

6.8.- LCD MODE DISPLAY SELECTION:

There are 3 display modes available:
Channel mode, Full display mode and Frequency+Channel mode.
1.- Holding the [FUN] key, turn on the transceiver, you can shift Channel mode and Frequency
mode.
2.- In Frequency mode, press [VFO] key to switch the display mode between "Full display mode"
and "Frequency+Channel mode".

6.9.- CHANNEL SELECTION:

● This function is only available in Channel mode and Frequency + Channel mode.
Press [UP] key to up channels; press [DOWN] key to down channels, or input the channel number
from keypad directly.
● If the Beep sound function is on, when you select the channels, the transceiver will indicate the
selected channel by voice message.

6.10.- FREQUENCY SELECTION:

● This feature is available in full screen mode. Use the [UP] / [DOWN] key to select the desired
frequency. Press the [DOWN] key to decrease the frequency; press the [UP] key to increase the
frequency.
Note:
- Before setting the frequency, you must set before the channel spacing. See channel spacing settings.
● In full screen mode, you can enter frequencies directly via the numeric keypad. Press [VFO] key
to erase wrong numbers.

6.11.- SCAN MODE:

This function will define the scanning mode.
Press [FUN] key to enter main menu, press [UP] / [DOWN] keys to select
"SCA08", press [PTT] key to enter scan mode. Press [UP] / [DOWN] keys
to select the scan mode. There are three scan modes available: TO, CO and
English - 11 -