Installation With Base - Joie signature i-Level Recline Manual De Instrucciones

Installation with base

see images -
1 11
1. Fit the ISOFIX guides with the ISOFIX anchor points.
guides can protect the surface of the vehicle seat from being torn.
They can also guide the ISOFIX connectors.
2. Unfold the load leg from storage compartment.
3. Extend the ISOFIX connectors by pressing the ISOFIX adjustment
button while pulling on the connector.
4. Press the ISOFIX adjustment button to adjust the ISOFIX
connectors. Line up the ISOFIX connectors with the ISOFIX guides,
and then click both ISOFIX connectors into the ISOFIX anchor
points.
4
!
Make sure that both ISOFIX connectors are securely attached to the
vehicle's ISOFIX anchor points. There should be two audible clicks
and the colors of the indicators on both ISOFIX connectors should
be completely green. -1
4
!
Check to make sure the base is securely installed by pulling on both
ISOFIX connectors.
5. After placing the base on the vehicle seat, extend the load leg to
floor 5 . When the load leg is installed correctly, the load leg
indicator will show green. Red will be shown when installed
incorrectly. -2 The load leg has multiple positions. When the load
5
leg indicator shows red this means the load leg is in the wrong
position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg adjustment button, then shorten the load leg
upwards. -1
5
6. The completely assembled base is shown as
!
The ISOFIX connectors must be attached and locked onto the
ISOFIX anchor points.
6
7
1
2
3
6
-1
!
The load leg must be installed correctly with green indicator.
!
Please install the enhanced child restraint on the rear vehicle seat
and then put the child in the enhanced child restraint.
7. Push the enhanced child restraint down onto the base
The ISOFIX
enhanced child restraint is secure, the enhanced child restraint
indicator will show green.
8. To release the enhanced child restraint, first take the child out of the
child restraint. Pull the child restraint release button
the child restraint up
be installed and released when in rearward facing mode.
9. To remove the base from the vehicle seat, push the secondary lock
buttons
on the ISOFIX connectors before removing the base from the vehicle
seat.
10.For transporting, press ISOFIX adjustment button and move the
ISOFIX connectors back into the storage position.
8
-2. The enhanced child restraint can ONLY
9
-1 first and then press the ISOFIX releasing buttons
10
10
-2
5
. If the
7
-1, then lift
9
-2
10
11
8