Technical Data
type
volt
163
230
Before initial use
Read these operating instructions
carefully before using the appliance
for the first time
• Clean the baking surface with a damp cloth.
• Grease the baking surface before using it for the first
time. Otherwise, greasing will not be needed due to
the non-stick coating
EN
• In case you use milk or corn-starch you should grease
the surface from time to time to avoid that the waff-
les stick on the coating.
• The two first waffles are unfit for human consump-
tion because of hygienical reasons.
Due to production residues smoke
can occure in the first minutes. For
that reason take care of a good
aeration during first heating up.
EC Label / Safety information
The appliance meets the require-
ments of the applicable EC direc-
tives.
The appliance is intended for in
door use only.
ATTENTION! Always unplug the
appliance before cleaning.
Preparation for use
• Remove all packaging elements and stickers, but not
the rating plate, serial number and the caution-hot-
surface sticker.
• Place the waffle maker on a dry, non-slip, even surface.
Safety information
• ATTENTION! The baking surfaces of the appliance
become hot during operation. Please avoid touching
the metal parts. Danger of being burned!
• Use only wooden or heat-resistant plastic utensils to
remove the waffles in order to prevent the non-stick
coating from being scratched
Starting up / Preheating
Plug the appliance into the wall socket. Set the controller
to 3 to preheat the appliance. Preheating in a higher level
should be avoided in order not to overheat the coat. The
orange control lamp lights up. After some minutes the
control lamp goes out and the green control lamp lights
up. Appliance becomes hot. Do not touch any part of the
appliance except the handles or the operating elements.
8
• After the preheating the browning regulator can
hz
watt
50/60
930
• Fill the dough in the rear part of the waffle maker, close
• Shortly after having filled in the dough the green con-
• After termination of the baking process the orange
• Take the waffle out of the waffle maker immediate-
• Put the waffles side by side on a baking grid.
• Use a paper towel to clean the appliance while still
• Tip: Place two absorbent paper towels between the
• Do not use caustic cleaning agents.
Baking
be adjusted as desired. Select a low setting for light
waffles or a high setting for dark waffles. The first
waffle does not exactly correspond to the browning
level selected, for this reason, you should wait until
the following waffle before changing the browning
level.
the appliance and press down the handles. This way,
the dough will spread even over the surface. Once the
orange light is on you do not need to co tinue pressing
anymore. The filling process should be quick, otherwise
the waffle will not be even browned in both sides.
trol lamp goes out. The orange control lamp lights up.
control lamp goes out and the green one lights up
again.
ly after termination of the baking process. We reco-
mend using a wooden fork.
Cleaning
warm.
baking surfaces and close the appliance Afterwards,
wipe the waffle maker with a damp cloth but never
under running water.
Environmentally friendly disposal
We use environmentally friendly packaging for the
transport of our appliances. Please recycle cardbo-
ard/ paper and plastic packaging appropriately.
ATTENTION!
Electrical appliances should not be
disposed of with the household trash.
Electrical appliances contain valuable raw materials.
When an appliance is worn-out, please take it to a
recognised recycling facility. Consult the local autho-
rities for information on recycling appliances.
Warranty
Cloer electrical appliances are in conformity with the
currently required EC-guidelines and safety regulati-
ons. If your Cloer electrical appliance has a defect or
it 10 11EN EN does not work properly, contact your
specialist dealer. Registered clients have at their dis-
posal our technical customer service.
Technical customer service
Mail: service-gb@cloer.com
https://service.cloer.com