Home Decorators Collection MAKENNA 52106 Guía De Uso Y Mantenimiento página 12

Assembly - Hanging the Fan (continued)
6
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod
mounting, the tab in the ring at the bottom of the
mounting bracket must rest in the groove of the
hanger ball. Failure to properly seat the tab in the
groove could cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two screws (SS)
and alignment post (LL) in the mounting bracket (A).
□
Push up the canopy (C) and turn it clockwise until the alignment
post (LL) engages to the round hole and the screws (SS) engage to
the key slots.
□
Firmly tighten the two mounting screws (SS).
□
Align the oval shape on the canopy (C) with canopy bottom cover
(II). Push up the canopy bottom cover (II) until the screw (SS)
heads engage to the slots on the canopy bottom cover (II) so that
the magnetic canopy bottom cover (II) can be attached to the
bottom of the canopy (C) properly.
Assembly - Attaching the Final Blade Assembly
1
Attaching the final blade assembly
to the motor
□
Attach the blade assembly to the motor assembly (E) by
aligning the screw holes on the blade arm (F) with the screw
holes on the bottom of the fan motor assembly (E).
□
Insert the screws (EE) into the holes on the blade arm (F) and
through the holes on the bottom of the fan motor assembly (E),
and tighten each screw to secure the blade assembly.
LL
E
12
A
SS
C
B
II
E
E
F
EE