Preparing The Remote Control - Home Decorators Collection MAKENNA 52106 Guía De Uso Y Mantenimiento

Preparing the Remote Control

1
Preparing the remote control
NOTE: The remote control has already been paired to the ceiling
fan for your convenience. If you have two of the same model fans
in your home, please follow the steps below to control each fan
independently.
NOTE: The remote control battery will weaken with age and
should be replaced before leaking takes place, as this will damage
the remote control. Dispose of used battery properly and keep the
battery out of the reach of children.
□
Remove the battery cover by pressing firmly on the arrow and
sliding the cover off.
□
Install two 1.5V AAA batteries (P) (included).
□
Slide the dip switch in the battery compartment to the "1" setting.
□
Confirm that the power to the fan is off at either the wall switch or
breaker box.
□
Return power to the fan at the wall switch or breaker box.
□
Press and release the "Learn" button located in the remote's
battery compartment within 30 seconds of turning on the power.
□
If pairing is successful, the fan's light kit will flash and the blades
will begin to spin.
□
Replace the battery cover on the remote control.
Assembly - Attaching the Accessories
Mounting the remote control holder
NOTE: Screw wall anchors are included for extra support. The
included screws are designed to screw easily into the wall. If
you would like a more permanent or secure hold, install the wall
anchors prior to attaching the wall cradle to the wall.
□
Slide the screw cover plate up to remove it from the wall
cradle.
□
Position the wall cradle in the desired position and attach it to
the wall using the included wall cradle screws.
□
Slide the screw cover plate back onto the wall cradle to
conceal the screws.
Screw cover plate
14