Zipro Dynamite Manual De Uso página 25

EN
HOW TO ADJUST THE SADDLE POST AND
BRACKET
CAUTION! When the post (18) is at the lowest
possible level, there may not be enough room to
tighten the quick release clamp (16). In such
a case, the lever can be moved,
To move the lever, pull the handle and rotate it to
the desired position. Then, release the handle.
Repeat if needed.
STEP 3.
CAUTION! Read this step carefully and follow it to
avoid damaging the bike permanently.
CAUTION! The right pedal is marked 'R', and the left
pedal is marked 'L'.
Take the left pedal (15 L), set it at 90°to the left
crank (29 L), and gently put it inside the crank (as
shown in the picture). Drive the bolt in the left
pedal (15 L) in counterclockwise and secure firmly
with a spanner.
Take the right pedal (15 R), set it at 90°to the right
crank (29 R), and gently put it inside the crank (as
shown in the picture). Drive the bolt in the right
pedal (15 R) in clockwise and secure firmly with a
spanner.
Remove the 2 cross-recess screws (35) and 2 flat
washers (36) from the main frame (1) with a
spanner.
Attach the water bottle holder (37) to the main
frame (1) with 2 cross-recess screws (35) and 2 flat
washers (36) with a screw driver. Put the bottle (38)
into the holder (37).
STEP 4.
Attach the computer (40) to the handlebar (26)
with 2 screws (41). Then connect the sensor cable
(39) to the computer (40).
Congratulations! You have assembled
magnetic bike!
Read the manual carefully before using the bicycle.
25