Publicidad
Idiomas disponibles
Idiomas disponibles
Disassembly
Disassembly and re-assembly should be done only with the assistance of the sectional
drawing and/or the exploded view. Observe the safety instructions of the operation and
maintenance manual.
Do not disassemble the tool until you know whether the problem is in one of the modules.
Then only disassemble the tool as necessary to repair as required.
Keep contaminants such as dirt and grit away from the internal parts at all times.
Always identify and correct the cause of the problem prior to re-assembling. Further wear and
tool failure can result, if the original cause is not eliminated.
Prior to separating the modules, determine exactly, if the problem is in the compressed air
supply or in one of the modules. The paragraph "Troubleshooting" of the operation manual
contains helpful information for exact identification of the problem.
Prior to disassembly
Clean outer surface of the machine.
Make sure that all new sealings are available for replacing the old ones during re-assembly.
Consider the installation direction of the sealings, before removing them. Install the new
sealings at the same position as the old ones.
Notice: The installation direction of the parts mentioned in the following process instructions
is indicated in the sectional drawings and parts list at the end of this instruction.
Spare Parts
Only genuine spare parts may be used. There is no warranty for damages and liability is
disclaimed, if nonoriginal spare parts and accessories are used.
SPARE PARTS LIST
REPAIR
53
Publicidad
