Ega Master MASTEREX 79989 Manual De Instrucciones página 56

Disassembling the pneumatic motor
- Remove 6 x socket head screw item 18 and pull the motor housing item 1 with the remaining
motor parts out of the motor cover item 17(see fig.5). Continue disassembling, if necessary.
The re-assembly is done in the reverse order.
Observe the following:
- Check o-rings, bearings and radial shaft sealings with regard to damages and replace, if
necessary.
When using assembly aids:
- Assembly aids must not cause damages.
Wear parts –especially the vanes – have to be replaced in time. Vanes are considered worn,
when their width is less than 9.5 mm.
56
Fig.5
RE-ASSEMBLY