IKEA STJARNSTATUS Manual Del Usuario página 19

EN
I
J
5. With steel clamp and screw, secure water
supply line to rear panel of refrigerator
as shown.
6. Coil excess water supply line (copper
tubing only), about 2½ turns, behind
refrigerator as shown and arrange coils
so they do not vibrate or wear against
any other surface. Do not kink tubing.
7. Turn ON water supply at shutoff valve
and tighten any connections that leak.
8. Reconnect refrigerator to electrical
power source.
9. To turn ice maker on, ensure Ice Maker is
enabled on display (LED will be lit) or set
the ice maker's On/off power switch to
the ON (freezer ice maker).
WATER SUPPLY CONNECTION
A
B
C
D
G
F
H
Figure 1
A
E
G
F
H
Figure 2
Parts
A Steel clamp
B Brass compression nut
C Ferrule sleeve
D Copper water line
E Braided flexible stainless steel water line
F Water valve bracket
G Water valve inlet
H Water valve
I Copper water line from household
water supply
J 6' (1.8 m) minimum braided flexible
stainless water line from household
water supply
Include enough tubing in loop to allow
moving the refrigerator out for cleaning.

NOTE
These instructions do not cover after
market ice maker installation. Instruc-
tions in after market ice maker kit should
be used.
IMPORTANT
Your refrigerator's water supply system
includes several tubing lines, a water filter,
and a water valve. To ensure that your wa-
ter dispenser works properly, this system
must be completely filled with water when
your refrigerator is first connected to the
household water supply line.
19