IKEA STJARNSTATUS Manual Del Usuario página 38

FILTER REPLACEMENT
More about your Advanced Water Filter
The ice and water filter system is
tested and certified to NSF/ANSI
Standards 42, 53, 401 and CSA
B483.1 for the reduction of claims
specified on the performance
data sheet.
Do not use with water that is microbiologi-
cally unsafe or of unknown quality without
adequate disinfection before or after the
system. Use systems certified for cyst
reduction on disinfected waters that may
contain filterable cysts.
Test & Certification Results:
• Rated Capacity - 125 gal/453 L
• Rated service flow - 0.50 gal/min.
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 lbs/in.²
• Recommended Minimum Operating
Pressure: 30 lbs/in²
38
Replacing Your Water Filter
You do not have to turn the water supply
off to change the filter. Be ready to wipe up
any small amounts of water released dur-
ing the filter replacement.
1. Turn Off the ice maker(s).
2. Remove the filter by pushing on the end/
face of the filter.
3. Slide the old water filter cartridge straight
out of the housing and discard it.
4. Unpack the new filter cartridge. Using
the alignment guide, slide it gently into
the filter housing until it stops against
the snap-in connector at the back of
the housing.
5. Push firmly until the cartridge snaps
into place (you should hear a click as the
cartridge engages the snap-in connector).
6. Press a drinking glass against the water
dispenser while checking for any leaks at
the filter housing. Any spurts and sput-
ters that occur as the system purges air
out of the dispenser system are normal.
7. After filling one glass of water, continue
flushing the system for about 4 minutes.
8. Turn On the ice maker(s).
9. Press and hold Water Filter on the
appliance control display for 3 seconds.
When the display changes from red to
green, the status has been reset.
EN