Safety Signs; Identification Label; Main Components - Stiga MP 900 Li 48 Manual De Instrucciones

3.1.3 User types
This machine is intended for use by consumers,
i.e. non-professional operators. It is intended for
"DIY" use only.

3.2 SAFETY SIGNS

The machine has various symbols on it (Fig. 1).
They are used to remind the operator of the
behaviour to follow to use it with the necessary
attention and caution.
Meaning of symbols:
Warning! Read the instructions
before operating the machine.
Warning! The failure to use
this machine correctly can be
hazardous for oneself and others.
Danger! Do not leave
the machine in the rain or
in damp conditions.
Danger! Always wear protective
gloves when using the chainsaw.
Warning! Falling objects.
Keep any persons on site
at a safe distance.
Danger! Electrocution. Keep
a distance of at least 15 m
from overhead line cables.
Danger! Always wear
head protection.
Danger! Wear anti-
slip safety boots
Danger! Wear protective
earplugs and goggles.
Warning! For battery and
battery charger see the
dedicated manual
ATTENTION
Any damaged or illegible decals must be replaced.
Order replacement decals from an authorised
service centre.

3.3 IDENTIFICATION LABEL

The identification label holds the
following data (Fig. 1):
1. Sound power level
2. Conformity marking
3. Month/Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Article code
8. Power voltage
Write the identification data of the machine in the
specific space on the label on the back of the
cover page.
ATTENTION
Quote the information on the product
identification label whenever you contact
an authorised service centre.
NOTE
The example of the Declaration of Conformity
is provided on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is composed of a series of main
components that have the following functions
(Fig. 1):
A. Motor: supplies the drive power to the cutting
means.
B. Controls: hand grip fitted with the main
throttle controls.
C. Rear hand grip: support hand grip located
on the rear of the control rod.
D. Front hand grip: support hand grip located
on the control rod.
E. Machine support: a piece which, when
attached to the battery backpack, helps
supporting the machine during operation.
Connection point: point in which the
F.
machine is attached to the battery backpack.
G. Battery backpack (accessory on request.
par.15.4): device used to store batteries.
H. Guide bar: supports and guides the toothed
chain.
EN - 7