Connect To Electrical Devices - CGM 3300I Manual Del Operador

6
When electrical device requires a large starting
current, please put the energy-saving switch in
the "OFF" position; When the starting current
required by electrical device is small, put the
energy-saving switch in the "ON" position.
After completing the operations above, the
generator can be connected to electrical devices.
WARNING
It is prohibited to start or close the generating
set when the output terminal of generating set
is connected to an electric device and the
electric device is in "ON" state.
3.

Connect to electrical devices

Inspect power cord for damage before using.
1.
There is a hazard of electrical shock from
crushing, cutting or heat damage.
Make sure that the generating set has been
2.
properly grounded. If the electric devices
require grounding, the generating set must
ground.
Make sure that the electric devices are in
3.
"OFF" position.
Allow the engine to stabilize and warm up for
4.
a few minutes after starting.
Connect and start the electric devices.
5.
Turn off all electric devices and disconnect
6.
them from the generating set.
If the generating set supplies for several loads
7.
or electric devices, start the smallest one first
and the largest one last.
If connected devices overheat, turn them off and
disconnect them from generating set.
21
WARNING