Operating; Operating Checklist - CGM 2200I Manual Del Operador

III. Operating
1.

Operating checklist

1 Operating Location
Only use OUTSIDE and place the generating set In
a well-ventilated area.
Only operate the generating set on a flat, level
surface and in a clean, dry operating environment.
Allow two feet clearance on all side of the
generating set while operating it outdoors.
Operate in specified area, if any problem on
applicable occasion, please consult the authorized
local authority. In some areas, generating set must
be registered with the local utility. Generating set
used to construction sites may be subject to
additional rules and regulations.
DANGER
TOXIC FUMES
The exhaust of the generating set contains carbon
monoxide, Using engine indoors CAN KILL
YOU!
NEVER use inside any building or any kind of
enclosure, EVEN IF doors and windows are
open. Place the generating set in a well-ventilated
and clean area. Note the wind direction and air
current when place the engine.
High altitude
This generating set may require a high altitude
carburetor kit to ensure correct operation at high
altitudes. Consult the authorized local dealer for
high altitude kit information if you always operate
your engine at altitudes above 5, 000 feet (1,500
meters).
CAUTION
Even with carburetor modification, generating set
horsepower will decrease about 3.5%for each
1,000 feet (300 meters) increase in altitude. The
effect of altitude on horsepower will be greater
than this if no carburetor modification is made.
CAUTION
Operation the engine at altitude below 5, 000 feet
(1,500 meters) with modified carburetor may
cause the generating set to overheat and result in
serious engine damage. Please restore factory
specifications of the carburetor at the dealer when
using the engine in a low altitude area.
2 Operating Condition
Check for loose or damaged parts, signs of oil or fuel
leaks, and any other condition that may affect proper
operation. Repair or replace all damaged or
defective parts immediately.