Starting The Generating Set - CGM 2200I Manual Del Operador

2.

Starting the generating set

1
Perform operating checklist and remove all loads.
2 (If applicable)
Turn the ventilation knob to "ON" position when
engine is running to make sure the fuel flowing.
3
Turn the two-in-one switch to the "RUN" position.
4
Turn the energy saving switch to the "ON" position.
(Note: Please set the energy-saving switch to "OFF"
position when it needs large starting current.)
5
(Suitable for recoil starting)
Pull out the choke lever to close the choke valve.
CAUTION
Choke position for starting may vary depending
upon temperature and other factors. If re-starting
a warm engine, there's no need to pull out the
choke lever.
6 Manual start
Recoil starting:
CAUTION
Check starter cord conditions before operating.
Have it replaced immediately by local authorized
dealer if cord is frayed.