Maintenance And Repair - Bosch Rexroth KU 1 Instrucciones De Montaje

32/38 Bosch Rexroth AG
9

Maintenance and Repair

WARNING
High electrical voltage!
Danger of severe injuries or death due to electric shock.

Make sure the relevant system component is not under pressure or
voltage before performing any maintenance or repair work.

Protect the system against being switched on.
High pneumatic pressure!
Danger of severe injuries or death.

Switch off the compressed air supply on the relevant system
component before performing any maintenance or repair work.

Protect the system against being switched on.
CAUTION
Hot electric motor surfaces during operation!
Possible burns if the hot surfaces (over 65°C) are touched

Provide appropriate safety devices to seal off the motors.

Let the system cool off for at least 30 min. before performing any
maintenance or repair work.
• Continuous conveyors that are in motion or operation may only be
inspected or adjusted if protective devices are present and correctly
positioned.
• Observe DIN EN 13857 when removing or replacing protective devices
and/or deactivating safety devices.
• Test runs with open housings are only permitted when they are
performed by skilled workers using hold-to-run controls and when the
infl uence of all other switching devices can be excluded.
TS 1 | 3 842 531 106/2013-04