Parts Included - Balanced Body The Contrology Manual Del Usuario

How to Install your Wire Stops on your
Contrology Springs

PARTS INCLUDED:

DESCRIPTION
Wire Stop
10-24 Set Screw
3/32" Allen Wrench
Start to thread a provided set screw into each wire stop, install the
set screw into the wire stop so about 1/4 of the set screw sticks out.
(Note they might be already in the wire stops, if they are, ensure
they are not going into the middle opening of the wire stop)
Go to the top mounted spring attached to your machine, See
Figure 6. Install a wire stop onto the end of the open hook. Slide
the middle opening of the wire stop onto the wire so that the wire
end is barely coming out the underside of the wire stop.
Make sure the wire stop length of the body is perpendicular to
the wire, See Figure 7. Use the provided Allen wrench to tighten
the set screw. Ensure the set screw is very tight to prevent them
from coming loose.
Repeat the above steps for the other springs with open ends.
There are (3) Push through bar springs, each getting one on the
frame end of the spring.
PART NO. QTY
17922 3
17931 7
17930 1
Figure 6
Figure 7
9