Milnor MilTouch MWF27Z8 Serie Guía Del Operario página 34

Chapter 2. How to Update the Machine Software
a. The controller creates a restore point to prevent data loss if the update process is
interrupted.
b. A progress bar indicates the progress of the update.
7. When the update is completed, the controller prompts you to start the controller.
8. Touch the Power Cycle Machine button. The machine controller will shut down and restart.
9. Remove the flash drive from the USB port.
How do I restore my formulas and configuration data?
2.1.4.
1. Be sure that the screen shows the Home screen.
2. If there is a flash drive in the USB port, remove it.
3. Touch the File Transfer button.
Some software versions show a dialog box with a check button
dialog box, confirm that nothing is connected to the USB port. The USB status light on the
File Transfer screen will be red.
4. Insert the flash drive into the USB port. The USB status light on the File Transfer screen
(Figure 29) will change from red to green.
If the USB status light does not change to green in 5 seconds, touch the Mount USB button
Tip:
above the Home button on the File Transfer screen.
5. Touch the Formula Set button in the External Memory area on the left side of the screen.
6. Touch the Right Arrow button.
7. Touch the Configuration Data button in the Machine Memory area on the right side of the
screen.
8. Touch the Default button in the External Memory area on the left side of the screen..
9. Touch the Right Arrow button to import the configuration data from the flash drive to the
machine.
10. Touch the Home button to return to the Home screen.
11. Remove the flash drive from the USB port.
PELLERIN MILNOR CORPORATION
— End of BICLUR02 —
30
(Figure 26). If you see this