Publicidad
Idiomas disponibles
Idiomas disponibles
K85Ec / KSS80Ec 370
Use the following procedure to install the roller
edge guide:
1.
Loosen the four wing screws (5).
2.
Insert the roller edge guide (E) into the guide
provided for this purpose.
It can be mounted on the left or right side
➢
of the machine.
3.
Tighten the four wing screws (5).
✓
The roller edge guide is installed.
Use the following procedure to adjust the
cutting width:
1.
Loosen the four wing screws (5).
2.
Adjust the roller edge guide (E).
3.
Tighten the four wing screws (5).
The cutting width is adjusted.
✓
6
Service and maintenance
MAFELL machines are of a low-maintenance design.
The installed ball bearings are lubricated for life. After a longer period of operation, MAFELL recommends that
the machine be handed over to an authorized MAFELL service workshop for inspection.
6.1 Storage
Clean the machine thoroughly if you will not use it for quite some time. Spray bare metal parts with a rust
inhibitor.
01/2022
Fig. 24: Installing the roller edge guide
Fig. 25: Adjusting the cutting width via the roller edge
guide
27
Publicidad
