Publicidad
Idiomas disponibles
Idiomas disponibles
NOTA: Si necesita instalar conductos, tenga en cuenta que la longitud total del conducto de 31/4 "x 10"rectangular o 6"
de diámetro de conducto redondo no debe exceder los 140 pies equivalentes.
La ventilación exterior requiere un conducto de escape de la campana. Lea atentamente lo siguiente.
NOTA: Es importante que la ventilación se instale utilizando la ruta más directa y con el menor número posible de
codos. Esto asegura una ventilación clara de los gases de escape y ayuda a prevenir bloqueos. Además, asegúrese de
que los amortiguadores se balanceen libremente y que nada esté bloqueando los conductos.
Exhaust connection:
The hood exhaust has been designed to made with a standard 3
If a round duct is required, a rectangular-to-round transiting adaptor must be used. Do not use less than a 6"diameter
duct.
Maximum duct length:
For satisfactory air movement, the total duct length of 3
exceed 140 equivalent feet.
Elbows, transitions, wall and roof caps, etc.,
section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the
equivalent lengths of all transitions and adaptors plus the length of all straight duct sections. The chart below shows you
how to calculate total equivalent ductwork length using the approximate feet of equivalent length of some typical ducts.
DUCT PIECES
Rectangular-to-Round
Transition Adaptor*
Wall Cap
90° Elbow
45° Elbow
90° Elbow
45° Elbow
Roof Cap
Straight Duct 6 " Round or
3¼" x 10" Rectangular
* IMPORTANT: If a rectangular-to-round transition adaptor is used, the bottom corners of the damper will
have to be cut to t, using the tin snips , in order to allow free movement of the damper. Equivalent
lengths of duct pieces are based on actual
with any vent hood.
Información general
"x10" rectangular duct.
1/4
"x10" rectangular or 6"diameter round duct should not
1/4
present additional resistance to
EQUIVALENT
x
LENGTH
5 Ft.
x
40 Ft.
x
10 Ft.
x
5 Ft.
x
25 Ft.
x
5 Ft.
x
24 Ft.
x
1 Ft.
x
Total Duct work
28
and are equivalent to a
NUMBER
EQUIVALENT
=
LENGTH
USED
( )
=
( )
=
( )
=
( )
=
( )
=
( )
=
( )
=
( )
=
=
Ft.
Ft.
Ft.
Ft.
Ft.
Ft.
Ft.
Ft.
F t.
Publicidad
