Publicidad
Idiomas disponibles
Idiomas disponibles
ÉCHAPPEMENT DU CAPOT
REMARQUE: Lisez ces deux pages suivantes uniquement si vous placez pour évacuer votre échappement vers l'extérieur. Si vous
prévoyez recirculer l'air dans la pièce, passez à la page 6.
ÉCHAPPEMENT SUPÉRIEUR EXTÉRIEUR (EXEMPLE SEULEMENT)
The following chart describes an example of one possible ductwork installation.
DUCT PIECES
Equivalent lengths of duct pieces are based on actual
performance with any vent hood.
* IMPORTANT: If a rectangular-to -round transition adaptor is used, the bottom corners of the damper will
have to be cut to t, using the tin snips, in order to allow free movement of the damper.
OUTSIDE BACK EXHAUST (EXAMPLE ONLY)
The following chart describes an example of one possible ductwork installation.
DUCT PIECES
Equivalent lengths of duct pieces are based on actual
performance with any vent hood.
NOTE: For back exhaust, case should be taken to align exhaust with space between studs, or wall should be
prepared at the time it is constructed by leaving enough space between the wall studs to accommodate exhaust.
Informations générales
Roof Cap
12 Ft. Straight Duct (6"
Round )
Rectangular-to-Round
Transition Adaptor *
EQUIVALENT
LENGTH*
Wall Cap
40 Ft.
3 Ft. Straight Duct
(3¼" x 10" Rectangular)
3 Ft.
90° Elbow
10 Ft.
EQUIVALENT
LENGTH
x
24 Ft.
x
12 Ft.
x
5 Ft.
x
Total Length
NUMBER
x
USED
x
(1)
x
(1)
x
(2)
Total Length
50
NUMBER
EQUIVALENT
USED
=
LENGTH
(1)
=
24 Ft.
(1)
=
12 Ft.
(1)
=
5 Ft.
=
41 Ft.
EQUIVALENT
=
LENGTH
=
40 Ft.
=
3 Ft.
=
20 Ft.
=
63 F t.
Publicidad
