Lincar 700 Serie Manual De Instalación, Uso Y Mantenimiento página 25

To extract the nozzles spy pilot burners inserted on particular
•
illustrated plan in the figure, to unscrew the gas tube
connected to spy; it's advisable to use contemporary the
spanner nr.10 and nr.12.
To substitute the nozzle of spy pilot plan burners with the one
•
adapted to the type of used gas consulting table 2.
Tab. 2
To regulate the minimum of burners with the by-pass screw as indicated on figure: for
•
BUTANE/PROPANE gas (G30/G31) the screw must be screwed till the bottom;
By-pass
Oven burner
To remove the front low band metal sheet placed under oven
•
door, to enter on injector oven burner.
To unscrew the burner nozzle and replaced it with the one
•
adapted to the type of used gas consulting table 1 on section
"Oven".
To substitute the nozzle of oven spy: unscrew the cap–screw,
•
then unscrewing completely the nozzle and replace it with the
one adapted to the type of used gas consulting table 3. To screw
the nozzle till to bottom. To reassemble the cap–screw and the
seal washer.
Tab. 3
Butane/Propane
Methane G20
40
Methane Butane/Propane
G20 G30/G31
35 20
for gas METHANE (G20)
place the burners knob to regulate, in minimum position
with the burner light up, to unscrew anticlockwise the by-
pass screw to obtain a minimum steady flame. The burner
flame's must remain ignited also in the passages from
maximum to minimum without cause backfires.
After the regulation seal the by pass with varnish.
•
G30/G31
20
25/80
mod. G00
Oven pilot nozzle