Publicidad
Idiomas disponibles
Idiomas disponibles
4.2.3 Feeding the Processor
The Food Processor has two feeding nozzles, each one with
its particularities.
PICTURE 08
- The Large Nozzle No. 01 (Picture 08) should be used to
process bigger food quantities (ex.: onions and potatoes),
for products with bigger dimension (cabbage, beet) and also
to cut in a specific direction (ex.: limes and tomatoes).
- The Small Nozzle No. 02 (Picture 09) should be used to cut
long products (carrots and coconuts).
Always use the Pushers in their respective nozzles and
never use other objects or hands to push food. In case of
damage, loss of the pushers, ask for replacement with the
Authorized Technical Assistance.
The products get out of the machine after being
processed by gravity. It is important to clean the housing
and Outlet Nozzle to avoid obstruction.
5. CLEANING
Step 1: Turn off the plug from the outlet.
Step 2: Disassemble the equipment (Item 3.5).
Step 3: Wash all the disassembling parts with warm water
and mild soap.
Never use water jets directly on the equipment, only
wash the disassembling parts when they´re disassembled.
Step 4: When washing the discs, handle with care. Do not
throw the discs one against the others or in other objects, to
preserve the blades.
Step 5: Clean the Housing and the Discs Housing with wet
fabric with warm water and mild soap.
Use Your QR Code Reader to access more
information regarding the cares needed
when handling stainless Steel.
6. MAINTENANCE
The maintenance must be a group of procedures that have
the objective of keeping the appliance in its best condition
of operation and increasing its life expectancy and safety.
* Cleaning – Check the item 5 Cleaning of this Manual.
* Electrical wiring – Check all the cables to avoid deterioration
and all the electrical contacts about their tightening and
corrosion.
* Turn on and off button, emergency button, reset button,
PICTURE 09
01
electric circuits, etc. Check the appliance so that all the
components are working correctly and that the operation
is working normally.
* Installation – Check the installation of your appliance
according to the item 2.1 Installation of this manual.
1 - Items to be verified and implemented monthly:
02
- Check the electrical installation;
- Check the outlet tension;
- Measure the operating current and compare it to the
nominal one;
- Check all the electrical terminal tightening of the appliance,
to avoid bad contact;
- Check the possible clearance of the shift of the electric
motor;
- Check the wiring and the electric cable to avoid its
overheating, deficient isolation and mechanical breakdown.
2 - Items to be verified and implemented every 3 months:
- Check the electric components as ON/OFF Switch,
Emergency Button, Reset Switch, and eletric circuit related to
overheating, deficient isolation and mechanical breakdown.
- Check possible loosens in the bearings
- Check retainers, o´rings, v´rings and other sealing systems.
Use Your QR Code Reader to access
more information regarding safety and
maintenance.
7
Publicidad
