Lifting And Handling - Casals QUANTICA EEC Manual De Instalación, Operación Y Mantenimiento

13.4 Lifting and handling

Each unit section or single piece unit is provided with appropriate lifting points (lifting lugs or perimeter holes for lifting bars)
clearly identified in the structural base.
When unloading the unit, it is strongly recommended that sudden movements are avoided in order to protect the internal
component of the unit. Lifting procedure to be followed in order to avoid any damages to side panels is schematically shown
on the pictures below, otherwise it is possible to proceed with the handling by means of forklifts.
It is important to keep the unit horizontal during the handling and lifting, avoiding absolutely to flip or tilt the sections.
Unit sections should be handled separately, before any assembly or coupling is made. After sections are assem-
bled, it is NOT possible to move the whole resulting unit.
Weight of each section or unit module, as well as the unit total weight, are shown in the technical documen-
tation supplied with the unit.
SPACER
LIFTING
HOLES
EN
28