Unit Use; Turn On The Unit And Setting Parameters (Control Basic) - Casals QUANTICA EEC Manual De Instalación, Operación Y Mantenimiento

18. UNIT USE

18.1 Turn the unit and setting parameters
ON
Once the unit is powered and the main switch is activated,
the display turns on and shows the "OFF" screen, the unit is
turned off by key. From this screen, it is necessary to press
and hold the "ON/STAND-BY" key in order to activate the unit
and go to the main screen.
When the unit starts, the display is similar to the one you can
see above. From this screen it is possible to access to all the
menu following explained. From the main screen, through press
and hold of the "SET" key, the USER MENU is accessible.
The user menu can be accessed through the display main screen
and it does not need Password.
In this menu are there the parameters that the user can freely
modify and will following explained.
In order to see the parameters on the USER MENU, press again
the "SET" key (simple pressure). By pressing the "DOWN" key,
all parameters are listed displayed.
(CONTROL BASIC)
LCD REMOTE DISPLAY WITH SEGMENTS
(CONTROL BASIC version only)
PRESS
AND HOLD
To change the operation mode:
• press the "SET" key, the value blinks;
• press the "UP" or "DOWN" keys to change the parameter;
• confirm with "SET" key.
"COOL" = SUMMER
"HEAT" = WINTER
PRESS
AND HOLD
To change the summer set-point:
• press the "SET" key, the value blinks;
• press the "UP" or "DOWN" keys to change the parameter;
• confirm with "SET" key.
To change the winter set-point:
• press the "SET" key, the value blinks;
• press the "UP" or "DOWN" keys to change the parameter;
• confirm with "SET" key.
Pressing the "DOWN" key scrolls through the various param-
eters until you reach the constant FLOW RATE and PRESSURE
setting screen.
EN
x 17 TIMES
44