Technical Data; Product Description; Installation - tormatic TAR1 Manual De Instrucciones Y De Montaje

3

Product description

Control elements
6
5
1 LED display
2 Extend support button
3 RETURN loading bridge
button
Programming control elements
1
3
4
1 LED display
2 LED spot (confirmation of
the programming entry)
Rating plate
The rating plate is located at the side on the control housing. Ob-
serve the power supply specifications.
1
7
Made in Germany
6 5 4
1 Control type
2 Manufacturer and address
3 Supply voltage
4 Amperage
14 - EN
4 Housing cover
5 Main switch
6 HEBEN loading bridge
button
2
5
3 Up navigation button
4 Down navigation button
5 Programming button
(Prog button)
2
3
5 Max. motor power
6 Protection type
7 WN number

Technical data

Height x width x depth
Cable feed-throughs
Supply voltage
1
2
Control voltage
Max. motor power
3
Protection type
Operating temperature
4
Manufacturer
4

Installation

Hazardous voltage
DANGER
The product runs on high voltage Before starting
with the installation,observe the following:
•
•
Follow the instructions as well as the illustrations in the
"Connection diagrams" chapter.
1. Tools required
For the assembly of the control, you require the following tools:
• wooden folding rule or tape measure
• cross-tip screwdriver Phillips; size 2
• drilling machine
• drill 6 mm
• Torx screwdriver, size T20
• slotted screwdriver for electricians
• spirit level
• marking pencil
2. Opening the control cover
Open the housing cover by either loosening the two screws on
the left or right on the cover.
3. Assembly of the control
Assemble the control as specified on the drilling drawing.
Selection of the place of installation
NOTICE
When selecting the place of installation, observe
the preconditions in compliance with the tech-
nical data.
4. Terminal designation
J1 External operation
J4 Emergency stop
J5 Door open sensor
J6 Wheel chock
J7 Key switch
TAR1 400V / 230V
250 mm x 215 mm x 120 mm
Assembled vertically
6 (4) x M20
2 x M16
2 x M20 V cutout
3N~ 400 V
3~ 230 V
24 V DC
1.5 kW
IP 54 (IP 65 optional)
-20 °C
Novoferm tormatic GmbH
Eisenhüttenweg 6
D-44145 Dortmund
www.tormatic.de
Have all work on electrical connections car-
ried out by a skilled electrician.
The power connection must be executed in
compliance with the mains voltage avail-
able.
+50 °C