Publicidad
Idiomas disponibles
Idiomas disponibles
Gather the required tools and parts before starting
installation. Read and follow the instructions provided with
any tools listed here.
Tools needed
• Drill
• 1¼" (3 cm) drill bit
•
³⁄ ₁ ₆" (0.5 cm) drill bit
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking compound
• Vent clamps
• Jigsaw or keyhole saw
• Metal snips
• Screwdrivers
•
Phillips
•
Flat-blade
Supplied Part
Strain relief connector
4.2x8 mm screws
6-wire blower connector
6.4x18 mm flat washers
6 x 16 mm screws
Spring tab
6.3x60 mm screws
Support bracket
Tools and Parts
Parts not supplied
• 6 AWG wires, one each of the following colors: black, white,
red, blue, gray, and green or green/yellow (ground)
NOTE: The length of the conduit and AWG wires is
determined by the distance between the in-line blower
motor and range hood terminal boxes.
•
11 - UL listed wire connectors
Parts supplied
Remove parts from packages. Check that all parts are
included.
• Shell for blower motor assembly
• Hardware bag with:
Pieces
2
10
1
4
4
1
7
1
Supplied Part
Ø 12 mm strain relief
6x13.5 mm
Torx adapter
4.2 x 15 screws
Strap 2.5x95 mm
Neoprene washers
10x50 mm wall anchors
Clip nuts
Pieces
1
2
T10
1
T20
1
10
3
20
7
4
5
Publicidad
