Power Save Mode; General Operation - Breville the Dual Boiler BES920 Manual De Instrucciones

POWER SAVE MODE

The machine will enter POWER SAVE mode
after remaining idle for 1 hour and turn off
completely if not used for a continuous
4-hour period.
Pressing any button during POWER SAVE
(except POWER) or operating the STEAM
LEVER or HOT WATER dial will cause the
machine to heat-up to operating temperature.
Pressing the POWER button during POWER
SAVE will turn the machine off.
LCD INTERFACE
Display modes
3 modes can be displayed on the LCD screen:
Shot Temperature, Shot Clock or Clock.
Press UP or DOWN arrow to change the
display mode.
1. Shot Temp
Displays selected extraction temperature.
The default is 200°F (93°C), but can be
changed from 190°F–205°F (86°C–96°C). See
'Extraction Temperature', page 14.
2. Shot Clock
Displays duration of espresso extraction in
seconds. See 'Extraction Guide', page 22.
Shot clock will be displayed during an
extraction and 10 seconds after the extraction
before returning to the default shot
temperature display mode.
3. Clock
Displays current time. The default is 12:00AM
if the time has not been set. See 'Set Clock',
page 14.
If selected, the clock will display for 10
seconds before returning to the default shot
temperature display mode.

GENERAL OPERATION

The 1 CUP & 2 CUP buttons use duration to
control espresso volume. The duration times
are preset but can be reprogrammed (refer
to 'Reprogramming Shot Duration', page 13).
Alternatively, access the Advanced Features if
you wish to use volumetric controls instead of
duration to determine espresso volume (refer
to 'Volumetric Control (vOL)',page 17).
1 CUP BUTTON
Press 1 CUP button once to extract a single
shot of espresso at the preset duration (30
seconds). The extraction will start using the
low-pressure pre-infusion.
The machine will stop after 30 seconds and
return to STANDBY mode.
TIP
To by-pass low pressure pre-infusion and
deliver water to the group head at full pump
pressure, press and hold the 1 CUP button.
Release button when the desired amount of
espresso has been extracted. This function can
be used when purging the group head.
11