Troubleshooting; Maintenance; Ordinary Maintenance; Routine Maintenance - CAMPAGNOLA P8 Manual De Uso Y Mantenimiento

5 - USE OF THE CHAINSAW

5.10 Troubleshooting

WARNING!
All the maintenance operations have to be performed by a mechanic.
FAULT
The chainsaw does not work.
The chain stops.
The chainsaw is not powerful enough.
Air leaks from the valve (16) of the
handle (17).
6

- MAINTENANCE

6.1 Routine maintenance

WARNING!
• Before carrying out any maintenance operation, disconnect the tool from the compressed air hose.
• All the maintenance operations which are not described in this manual have to be performed in a CAMPAGNOLA
S.r.l. Authorized Service Point.
The routine maintenance operations may be carried out by the operators.
WARNING!
All the maintenance operations have to be carried out keeping the chain brake activated.
30 - 120
CAUSE
a) The air regulator in the compressor is
closed.
b) The air hose is clogged.
c) The ON/OFF switch (18) is in OFF
position.
d) The inertial chain brake (28) is in-
serted.
e) The chain (11) is not tensioned
enough.
a) The lubrication is not enough.
The oil level in the reservoir is low.
a) The air hose is dirty inside.
b) The compressor pressure is not
enough.
c) The motor is not lubricated.
a) The valve (16) gaskets are worn out
or damaged.
REMEDY
a) Adjust the pressure regulator at 10
bar.
b) Disconnect the air hose and check
it and the couplings for inner clean-
ness.
c) Put the switch in ON position.
d) Free the brake by pulling the hand
guard (8) backwards.
e) Regulate the chain (11) tension by
using the adjusting screw (33) of the
bar (10).
a) Fill the reservoir up (26) by using the
tap (23).
a) Disconnect the air hose and blow
compressed air to remove impurities.
b) Check that the compressor pressure
reaches 10 bar.
c) Check the oil level in the compressor
lubricator.
a) Disassemble the handle (17) valve
and replace the gaskets even if only
slightly worn out.