Publicidad
gasoline
WARNINg
Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel machine indoors
or while the engine is hot or running. Extinguish cigarettes, cigars,
pipes, and other sources of ignition.
CAUTION
Alcohol blended fuels (called gasohol or using ethanol or methanol)
can attract moisture which leads to separation and formation of acids
during storage. Acidic gas can damage the fuel system of an engine
while in storage.
CAUTION
To avoid engine problems, the fuel system should be emptied
before storage for 30 days or longer. Drain the gas tank by starting
the engine and letting it run until the fuel lines and carburetor are
empty. Use fresh fuel next season. See STORAGE Instructions for
additional information.
CAUTION
Never use engine or carburetor cleaner products in the fuel tank or
permanent damage may occur.
1.
Remove fuel cap from the fuel tank.
2.
Make sure the container from which you will pour the gasoline is
clean and free from rust or foreign particles. Never use gasoline
that may be stale from long periods of storage in its container.
Gasoline that has been sitting for any period longer than four
weeks should be considered stale.
3.
Fill fuel tank with clean, fresh, unleaded regular gasoline only.
Replace fuel cap.
NOTE: Check the fuel level periodically to avoid running out of
gasoline while operating the tiller.
TO START ENgINE
Electric Starter
Determine that your home's wiring is a three-wire grounded system.
Ask a licensed electrician if you are not certain.
If you have a grounded three-prong receptacle, proceed as follows:
1.
Attach spark plug wire and rubber boot to spark plug.
2.
Place the gear selection lever in NEUTRAL.
OPERATION
3.
Plug an extension cord into the outlet located on the engine's surface.
Plug the other end of extension cord into a three-prong 120-volt,
grounded, AC outlet in a well-ventilated area See Figure 12.
4.
Push the choke lever to the CHOKE
is warm, place the choke in the RUN
CHOKE
5.
Move throttle control to START/RUN (Rabbit)
Figure 10. Push starter button to start engine.
6.
Once the engine starts, release starter button.
7.
Allow the engine to warm up several minutes, adjusting choke
toward RUN
each choke adjustment.
8.
ALWAYS keep the throttle control in the START/RUN (Rabbit
position when operating the tiller.
13
Figure 12
position. If the engine
position instead of
. See Figure 13.
Figure 13
position. Wait until engine runs smoothly before
position. See
Publicidad
Solución de problemas
