Step Flanger - Roland SPD-SX PRO Manual De Referencia

Step Flanger

This is a flanger in which the flanger pitch changes in steps.
The speed at which the pitch changes can also be specified in terms of a note-value of a specified tempo.
Parameter
OFF, LPF, HPF
Filter Type
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600,
Cutoff Freq
2000, 2500, 3150, 4000, 5000, 6300, 8000 [Hz]
0.0–100.0 [msec]
Pre Delay
OFF, ON
Rate (sync
sw)
Rate (Hz) 0.05–10.00 [Hz]
Note
Rate (note)
Ø Note(P.202)
Depth (*1) 0–127
Phase 0–180 [deg]
-98–+98 [%]
Feedback
OFF, ON
Step ()
Step Rate 0.10–20.00 [Hz]
(Hz)
Step Rate Note
Ø Note(P.202)
(note)
Low Gain -15–+15 [dB]
High Gain -15–+15 [dB]
D100:0W–D0:100W
Balance
Level 0–127
*1: This parameter corresponds to MFX Ctrl. For details, refer to
Ctrl)(P.203)".
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to
EFFECT (MASTER EFFECT CTRL)(P.204)".
Value
"Control del MFX con los mandos PAD EDIT [1] [2] (MFX
Explanation
Type of filter
OFF: No filter is used.
LPF: Cuts the frequency range above the Cutoff Freq
HPF: Cuts the frequency range below the Cutoff Freq
Basic frequency of the filter
Adjusts the delay time from the direct sound until the flanger
sound is heard.
If this is ON, the rate synchronizes with the tempo of the
rhythm.
Ø
Cómo tocar junto con el clic (metrónomo)#KIT
TEMPO(P.32)
Frequency of modulation
Depth of modulation
Spatial spread of the sound
Adjusts the proportion of the flanger sound that is fed back
into the effect. Negative (-) settings will invert the phase.
If this is ON, the rate synchronizes with the tempo of the
rhythm.
Rate (period) of pitch change
Gain of the low range
Gain of the high range
Volume balance between the direct sound (D) and the
flanger sound (W)
Output Level
"Control del MASTER EFFECT con el mando MASTER
Effect List (English)
183