Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OPERATION
Using the Side-Mounted Bidet
WARNING: Risk of scalding. High water temperature can cause severe burns.
Be sure to set the water temperature for your hot water heater at or below 120 °F
(49 °C) and use extreme caution when mixing hot and cold water during use.
Brondell is not liable for any misuse of product or failure to use caution when
Side-Mounted Bidet Dual Temperature (SMB-25) Only:
To adjust water temperature (when both hot and cold
water are connected), slowly push pressure control
handle forward and incrementally turn handle clockwise
towards "WARM" (indicated by red dash) until the desired
temperature is reached.
NOTES: There may be a delay in the warm water
reaching the bidet attachment as the cold water in
your pipes clears and is replaced with hot water
(similar to the delay when you turn your faucet on).
If only connected to cold water, make sure that the
temperature dial on the bidet attachment is turned
as far as it can go towards the "COOL" setting for
best pressure adjustability.
10
connecting to hot water.
Publicidad
