Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Connecting the Hot Water Supply
1. Connect The Hot Water Supply.
a. Locate the hot water supply line in your bathroom
under your sink/washbasin and turn the water supply
valve all the way off.
b. Drain the hot water line by turning the sink tap on the
hot setting until no more water comes out.
c. Disconnect hot water supply hose to sink from shut off
valve. You may have to use a ⅜" compatible wrench or
a similar tool (not supplied).
NOTE: There may be some residual water in the
hose; use a small container or towel to catch any
residual water.
2. Install the Hot Water ⅜" T-Valve and the small rubber
washers as needed onto the hot water shut off valve
under the sink.
3. Reconnect hot water supply line to open end (top) of
T-valve.
4. If not already removed, unscrew the pressure cap
covering the pressure connector on the T-valve.
a. Slide the pressure cap over the open end of the of
hot water flex tubing with the inside threads facing
towards the open end.
b. Push the hot water flex tubing over the pressure
connector.
IMPORTANT: Be sure to slide the hot water flex
tubing over the pressure connector until the tubing
slides past the "lip" of the pressure connector and
it cannot go any further.
c. Slide the pressure cap down until the cap meets the
pressure connector. Screw the cap onto the T-valve
until secure and tight.
CAUTION: Do not over-tighten the pressure cap.
You will risk damaging the tubing.
6
Step 1c
Steps 2-3
Step 4a
Step 4b
Step 4c
Publicidad
