Installation - brondell SMB-15 Manual Del Propietário

PRODUCT INSTALLATION

Installation

Please read these instructions carefully before installing your
Side-Mounted Bidet. Failure to do so could result in flooding,
leaking or damage to the product.
1. Existing Toilet Seat Removal.
a. Lift hinge covers and use flathead or Phillips head
screwdriver to remove the mounting bolts. Alternatively, you
may need to loosen mounting bolts underneath the seat.
b. Remove the toilet seat and set the seat, mounting bolts
and hardware aside.
2. Turn Off Water Supply Valve And Flush Toilet.
a. Turn water supply valve off to stop the flow of water.
b. Flush toilet and hold down handle to completely empty tank.
c. Disconnect water supply hose from toilet tank.
Do not disconnect from the water supply valve.
3. Connect Cold Water T-Valve To The Toilet Tank Fill Valve.
a. Install the ⅞" cold water T-valve with one or both of the
large rubber washers to the incoming water connection
on the bottom of your toilet tank.
b. Connect the cold water supply line coming from the wall
to the bottom of the T-valve.
4. Connect Bidet Hose To T-Valve.
Connect one end of the braided metal cold water bidet
hose to the remaining open side of the installed T-valve.
FOR AMBIENT TEMPERATURE MODEL, STOP HERE AND
PROCEED TO "INSTALLING THE BIDET ATTACHMENT" ON
PAGE 7. FOR DUAL TEMPERATURE MODEL, CONTINUE.
5. Install The Hot Water Supply Cap.
a. If you are only connecting the cold water supply, then you
must install the hot water supply cap (provided - see Page 3)
over the hot water connection on your bidet (see diagram).
b. After installing hot water cap, proceed to "Installing the
Bidet Attachment" on Page 7. If you wish to also connect
your hot water supply, proceed to "Connecting the Hot
Water Supply".
IMPORTANT: Failure to connect or cap the hot water
supply will result in leaking during use.
Step 1b
Step 2c
Step 3a
Step 3b
Step 4
Step 5a
5