Auxiliary Socket For Usb Accessories; Warning Buzzers; Pushbutton Panel - ST R72 Li 48 V1 Manual De Instrucciones

6.6 AUXILIARY SOCKET FOR
USB ACCESSORIES
This socket (fig. 6.I) can charge USB
devices. It only has a recharging function.
The socket has no communication function
with the connected USB device.
The socket is only live when the
key (fig. 6.A) is fully inserted.
Do not recharge the accessory connected
to the USB socket in rainy, humid or high
temperature conditions with direct exposure
to sunlight. Use in these conditions invalidates
the warranty and waives the Manufacturer
from any liability in the event of problems.
Do not open the USB plug in rainy or dusty areas.
The Manufacturer declines any and all liability in
the event of damage to the accessory connected
to the USB socket or loss of data during its use.

6.7 WARNING BUZZERS

• A double buzzer signal indicates that the
grass catcher has not been fitted. Check
the presence or correct assembly of the
grass catcher or the presence of the
rear unload guard kit (see par. 16.3).
• A continuous buzzer signal indicates that the
grass catcher is full. Empty it (see par. 7.5.4).
• A single buzzer signal indicates the lack of
consent for reverse cutting. See icon fig. 7.C.
• An intermittent and repeated buzzer
signal indicates the operator is not
seated with the key inserted.
• A triple buzzer signal indicates the lack
of consent for activating the cutting
means. Make sure that at least 3
batteries are fitted in the machine.

6.8 PUSHBUTTON PANEL

Depending on the model, the machine can be
equipped with one of the pushbutton panel
versions (fig. 6.C, fig. 6.D) described below: :
6.8.1 Pushbutton panel (type "I") fig. 7
Machine start button
With the key fully inserted (fig.
6.A), this button (fig. 7.A) turns
the machine ON and enables
all functions. Activation is
signalled by an audible "beep".
NOTE
If all safety conditions are met,
the "READY" icon comes ON
(fig. 7.K) and the machine is
ready to be used (see par. 7.4).
Cutting means engage and
disengage pushbutton
Press the button fig. 7.B to engage/
disengage the cutting means.
• When the cutting means
are engaged, they become
operational after a few seconds.
• When the cutting means are
disengaged, a brake is applied
simultaneously to stop them
rotating after a few seconds.
NOTE
If the cutting means are engaged
without taking the necessary
safety precautions, the machine
shuts down and cannot be
restarted (see par. 7.2.2)
Reverse gear cutting
enable button
Holding down the button
fig. 7.C gives consent for
reverse mowing.
For reverse cutting, engage the
cutting means and simultaneously
hold down the button.
NOTE
A single buzzer signal indicates the
lack of consent for reverse cutting.
Beacon ON button
Pressing the button fig. 7.D turns
the LED beacon on/off. When
the beacon is ON, icon fig.
7.L is illuminated
EN - 12