Replacing Led Lamps; Storage; Handling And Transport; Assistance And Repairs - ST R72 Li 48 V1 Manual De Instrucciones

9.3.5 Repairing or changing tyres
The tyres are "Tubeless" and so all punctures
must be repaired by a tyre repairer following
the procedures required for this type of tyre.

REPLACING LED LAMPS

9.4
If the LED beacon fails, contact an
Authorized Service Centre.

10. STORAGE

When you intend to put your machine
away for more than 30 days:
1. Remove the ignition key.
2. Clean the machine thoroughly.
3. Check the machine for any
damage. If necessary, contact the
authorised service centre.
4. Store the machine:
• with the cutting means assembly lowered
• in a dry place;
• protected against poor weather
conditions, at a recommended
temperature of between 0 and +40 °C.
• covered with a sheet if possible;
• in a place out of children's reach;
• making sure that keys or tools used
for maintenance are removed.
ATTENTION
Make sure that the battery is fully charged at
least once a month and always before use.
When re-starting the machine, set it up as
indicated in chapter "7. "Using the machine" .

11. HANDLING AND TRANSPORT

• When handling the machine, always:
1. disengage the cutting means;
2. bring the cutting means assembly
to the highest position;
3. switch off the machine and
remove the ignition key
4. disengage the drive (par.6.3).
• When transporting the machine
on a vehicle or trailer, always:
• use an access ramp of suitable
strength, width and length;
• load the machine with the electric motor
switched off, with the key removed from
the ignition, without a driver and pushed
by an adequate number of people;
• lower the cutting -device assembly;
• position it so that it does not
cause a hazard to anyone;
• engage the drive (par.6.3).
• lock it firmly on the means of transport
using ropes or chains to prevent it from
tipping over and possible damage.
SAFETY INSTRUCTION
If you feel unable to carry out handling
or transport in safe conditions,
contact the Service Centre.

12. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorised Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the warranty and all obligations
and responsibilities of the manufacturer.
• Only Authorised Service Centres can carry
out guaranteed repairs and maintenance.
• The Authorised Service Centres only
use genuine spare parts. Genuine
spare parts and attachments have been
designed specifically for machines.
• Non-original parts and attachments are
not approved; use of non-original spare
parts and attachments will jeopardise
the safety of the machine and relieve the
Manufacturer from all obligations or liabilities.
• It is advisable to send your machine
once a year to an Authorised Service
Centre for servicing, assistance
and safety device inspection.

13. WARRANTY COVERAGE

The warranty conditions are intended for
consumers only, i.e. non-professional operators.
The warranty covers all material quality
and manufacturing defects recognised
during the warranty period by your Dealer
or Authorised Service Centre. The warranty
is restricted to the repair or replacement
of components recognised as faulty.
EN - 25