Troubleshooting; When Attempting To Light My Grill, It Will Not Light Immediately; Regulator Makes Noise; Grill Only Heats To 200-300 °F (93-149 °C) - Amazon Basics B0B8R16CS2 Manual Del Usuario

EN

Troubleshooting

If the grill is not functioning properly, try the following solutions.
NOTICE
For more FAQ and information, go to www.amazon.com/dp/B0B8R16CS2
Problem

When attempting to light my grill, it will not light immediately.

Solutions
Make sure that the liguid propane tank is not empty.
»
Make sure that you have a spark while you are trying to light the burner. If no spark, make sure that the battery is
»
installed properly.
Make sure that the wire is connected to the electrode assembly.
»
Clean wire(s) and / or the electrode with rubbing alcohol and a clean swab. Wipe with a clean cloth.
»
Check to see if the other burners operate. If so. check the gas orifice on the malfunctioning burner for an obstruction.
»
Problem

Regulator makes noise.

Solutions
The vent hose on the regulator may be plugged or the regulator may be faulty. Make sure that the vent hole on the
»
regulator is not obstructed. Clear the hole and close the gas control valves. Wait ten minutes and re-start.
Check your flames for proper performance. If the flames are not correct, replace the regulator.
»
Problem
Grill only heats to 200-300 °F (93-149 °C).
Solutions
Make sure that the fuel hose is not bent or kinked.
»
Make sure that the grill area is clear of dust.
»
Make sure that the burner and orifices are clean.
»
Make sure that this is an adequate gas supply is available.
»
Check for spiders and insects.
»
The regulator has a safety device that restricts the flow of gas in the event of a leak. This safety device can be triggered
»
without a gas leak. To reset the safety device, turn off all burners and close the LP tank valve. Disconnect the regulator
from the LP tank and wait one minute. Reconnect the regulator to the LP tank and slowly open the LP tank valve until the
valve is fully open. Light all burners and observe the temperature.
Problem

Grill takes a long time to preheat.

Solutions
Normal preheat 500-600 °F (260-316 °C), takes about 10-15 min. Cold weather and wind may effect your preheat time.
»
If you are using volcanic rock or briquettes, they can increase the preheat time and maximum temperature. Do not use
»
rocks or briquettes.
Problem

Burner flames are not light blue.

Solutions
Too much or not enough air for the flame.
»
Elevation is the principal cause, however cold weather can affect the mixture. Burner adjustment may be required.
»
Grill is in a windy location.
»
Check for spiders and insects.
»
Call Customer Service at 1-800-913-8999, Monday – Friday from 8 a.m. – 5 p.m. PST
»
20
PR-KMY0YMPZVX_B0B8R16CS2_6 burner Gas Grill_User Man_V1_EN_BK1.indb 20 PR-KMY0YMPZVX_B0B8R16CS2_6 burner Gas Grill_User Man_V1_EN_BK1.indb 20 10/11/2022 2:45:01 PM 10/11/2022 2:45:01 PM