Eiki EIP-2500 Manual Del Propietário página 21

4. Adjust the projected image with the Setup Guide
1
After the projector turns on, the Setup Guide appears. (When "Setup Guide" is set to "On". n
page 42)
2
Follow the steps in the Setup Guide and adjust the focus, screen size, and height (angle).
3
After adjusting the focus, height (angle) and screen size, press pENTER to finish the Setup
Guide.
5. Turn the computer on
6. Select the INPUT mode
Select the "INPUT 1" using the INPUT button on the projector or C INPUT 1 on the remote
control.
• When pressing the INPUT button on the projector, input mode switches in the following
INPUT1 INPUT2
order:
• When using the remote control, press the CINPUT 1/CINPUT 2/DINPUT 3/EINPUT
4 button to switch the INPUT mode.
7. Correct trapezoidal distortion
Correcting trapezoidal distortion using the Keystone Correction. (Keystone Correction functions
automatically on EIP-2500.)
On the projector
On the remote control
8. Turn the Power off
Press the STANDBY-ON button on the projector or the STANDBY button on the remote control,
and then press the button again while the confirmation message is displayed, to put the projector
into standby mode.
projector
• Unplug the power cord from the AC outlet after the cooling fan stops.
EIP-2500_EN_PR_e
On the remote
On the
control
projector
INPUT3 INPUT4
Shrinks
upper side.
On the remote
On the
control
17
_P. 28
On-screen display (RGB)
_P. 30
_P. 31
On-screen Display
_P. 27
05.7.5, 1:22 PM
Shrinks
lower side.
17