Controlling The Projector By A Computer; Connecting The Power Cord - Eiki EIP-2500 Manual Del Propietário

Controlling the Projector by a Computer

When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS-
232C adaptor and an RS-232C serial control cable (cross type, commercially available), the com-
puter can be used to control the projector and check the status of the projector. See page 54 for
detail.
When connecting to a computer
using an RS-232C serial control
cable and a DIN-D-sub RS-232C
adaptor
Computer
To RS-232C terminal
RS-232C serial control cable (cross type, commercially available)
Note
• The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the
owner's manual of the computer for details.
• See page 53 for connection of an RS-232C serial control cable.
Info
• Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This
may damage your computer or projector.
• Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on.
This may damage your computer.
Connecting the Power
Cord
Plug the supplied power cord into the
AC socket on the rear of the projector.
26
EIP-2500_EN_PR_g
DIN-D-sub RS-232C
adaptor
Supplied
accessory
AC socket
26
DIN-D-sub
Supplied
RS-232C
accessory
adaptor
To RS-232C
terminal
Power cord
05.7.5, 1:24 PM