Adjusting the Projected Image
("SCR - ADJ" menu)
1 Setting the Resize Mode
1
1
1
1
Note
• For details of the Resize mode, see pages 32
and 33.
• You can also press HRESIZE on the remote
control to set the resize mode. (See page 32.)
2 Adjusting the Image
2
2
2
2
Position
You can move the projected image vertically.
O button
Note
• You cannot set this item when "Resize" is set
to "Normal".
EIP-2500_EN_PR_j
Picture
SCR - ADJ
1
Resize
2
Image Shift
3
Keystone
Auto Keystone
4
OSD Display
5
Background
6
Setup Guide
7
PRJ Mode
8
Language
SEL./ADJ.
ENTER
"Auto Keystone" can be operated only when using EIP-2500.
*
Q button
41
Menu operation n Page 37
PRJ - ADJ
Help
Normal
0
0
Off
On
Logo
On
Front
English
END
3 Keystone Correction
3
3
3
3
When the image is projected either from the top
or from the bottom towards the screen at an
angle,
the
image
becomes
trapezoidally. The function for correcting trap-
ezoidal distortion is called Keystone Correction.
a When using EIP-2500
For Auto Keystone Correction
Set "Auto Keystone" on the "SCR - ADJ"
menu to "On".
For Manual Keystone Correction
Set "Auto Keystone" on the "SCR - ADJ"
menu to "Off", select "Keystone", and
then adjust with the slide bar.
Manual Correction
Q or P button
a When using EIP-200
Select "Keystone" on the "SCR-ADJ"
menu and adjust with the slide bar.
See page 31 for details of Keystone Correction.
Note
• The Keystone Correction can be adjusted up
to an angle of approximately ±13 degrees with
the "Auto Keystone" and up to an angle of
approximately ±13 degrees with the manual
"Keystone" (when "Resize" is set to "Normal").
05.7.5, 1:27 PM
distorted
O or R button
41