EdilKamin CALGARY Instalación Uso Y Mantenimiento página 30

COMPONENTS - SAFETY AND DETECTION DEVICES
Smoke thermocouple
on the smoke outlet. It reads the smoke temperature. It regula-
temperature is too high or too low (Stop Flame or Overheated
Smoke).
Feed Screw safety thermostat
Placed near the pellet hopper. It disconnects the electrical sup-
ply to the gear motor if the temperature detected is too high.
Water temperature detector
It reads the water temperature in the boiler and sends the circuit
board information for pump management and boiler power
modulation.
Water overheating safety thermostat
detects the water temperature in the thermo-stoves. If this is
electrical supply to the gear motor.
If the thermostat has been tripped it must be reset using the re-
set button behind the boiler after having removed the protective
cap.
Overpressure valve
is triggered to discharge the water and consequently the water
must be topped up.
sewage system.
Resistance
It sets off of the combustion of the pellets and it remains lit until
Smoke extractor
via a vacuum.
Gear motors
sferred from the hopper to the combustion chamber.
Pump (circulator)
Closed expansion tank
de the due to the heating effect.
Aheating technician must evaluate the need to add a second
tank to the existing one, depending on total amount of wa-
ter in the system.
N.B.:
IF THE BOILER BLOCKS, THE REASON WILL APPEAR ON THE DISPLAY AND THIS WILL BE SAVED.
Manometer
located on the rear it allows reading the pressure of the water
in the boiler. The recommended pressure is 1.5 bar when the
boiler is on.
Inner door opening detection microswitch
when the inner door is correctly closed.
Drain tap
the water inside the boiler must be emptied.
Manual relief valve
ding of water inside the boiler.
V2
-
-
- 30
-
PELLET
LOADING
DOOR
V1
V3
-