EdilKamin CALGARY Instalación Uso Y Mantenimiento página 39

Shutdown
While the boiler is working pressing the 0/1 key for 2 seconds
minutes).
The turning off phase includes:
-The interruption of falling pellets
-The circulation of running water.
Never pull the plug during shutdown.
N.B. Please note that the circulator runs until the water tempe-
Setting the clock
to follow the instructions given on the display to access the
This allows you to set the time on the electronic control board.
on the display).
Programmer to ignite and shutdown the boiler at various
times during the week.
function and press the + key to access the weekly timer fun-
The timer allows you to set a number of ignitions and
following options will appear:
- No Prog. (no program is set)
- Program/daily (a single program is set for every day)
- Program/weekly (a program is set for each day of the week)
Move from one to the other using the + and – keys.
and access the selection of the number of programs (ignition/
shutdown) to be set per day.
for every day of the week.
The following will be displayed if the + key is pressed:
- No Prog.
The display shows: 1 Ignition Hour 10.30; use the +/– keys to
The display shows: 1 Ignition Minutes 10.30; use the +/– keys
day to which the program is to apply:
1 Mon; 2 Tues; 3 Wed; 4 Thurs; 5 Fri; 6 Sat; 7 Sun
Once you have chosen the day by scrolling through them with
INSTRUCTIONS FOR USE
-
-
- 39
each day of the week and choosing the number and times of
interventions.
Should you make a mistake whilst setting the programs you
will appear on the display.
Pellet reserve warning
The boiler are equipped with an electronic pellet detection
system.
The pellet detection system is integrated into the electronic
pellets are left.
in operation mode.
implemented by the DEALER).
load and consume a full sack of pellets.
This allows for a brief running-in of the loading system.
Subsequently load 15 kg of pellets.
Then press the 'reserve' button once, thereby storing the
data into the memory that 15 kg have been loaded.
From now on the display will show the remaining pellets as
ded you must enter the quantity.
to enter this into the memory.
the quantity using the pellet reserve menu as follows:
Press + or – consecutively to view T. Max exit.
pellets will be displayed + that being loaded (default is 15 and
can be changed using the +/- keys).
-
-