Panel Installation - HTW ADMIRA Manual De Usuario E Instalacion

Panel Inst allat ion
CAUTION
DO NOT place the panel facedown on the
floor, against a wall, or on uneven surfaces.
(A)
Super-Slim models
St ep 1: Remove t he f ront grille.
1. Push both of the tabs towards the middle
simultaneously to unlock the hook on the
grille.
2. Hold the grille at a 45° angle, lift it up
slightly and detach it from the main body.
St ep 2: Remove t he inst allat ion covers at t he
f our corners by sliding t hem out w ards.
St ep 3: Inst all t he panel
Align the front panel to the main body, taking
into account the position of the piping and
drain sides. Hang the four latches of the
decorative panel to the hooks of the indoor
unit. Tighten the panel hook screws evenly at
the four corners.
NOTE: Tighten the screws until the thickness
of the sponge between the main body and the
panel reduces to 4-6mm (0.2-0.3"). The edge of
the panel should be in contact with the ceiling
well.
Adjust the panel by turning it to the arrowed
direction so that the ceiling opening is
completely covered.
Piping side
Drain side
Screwdriver
1. Connect the two louver motor connectors
to the corresponding wires in the control
box.
Control box
Connect the
louver motor
92
Latch
Connect the
louver motor