HTW ADMIRA Manual De Usuario E Instalacion página 93

2. Remove foam stops from inside the fan.
3. Attach the side of the front grille to the
panel.
4. Connect the display panel cable to the
corresponding wire on the main body.
5. Close the front grille.
6. Fasten the installation covers at all four
corners by pushing them inwards.
NOTE: If the height of the indoor unit needs
to be adjusted, you can do so through the
openings at the panel' s four corners. Make
sure that the internal wiring and drainpipe
are not a ected by this adjustment.
Water condensation
CAUTION
Failure to tighten screws can cause water
leakage.
Gap not allowed
CAUTION
If the unit is not hung correctly and a gap exists,
the unit' s height must be adjusted to ensure
proper function. The unit' s height can be
adjusted by loosening the upper nut, and
adjusting the lower nut.
Loosen upper nut
Adjust lower nut
93
Compact models
St ep 1: Remove t he f ront grille.
1. Push both of the tabs towards the middle
simultaneously to unlock the hook on the
grille.
Grille hook
2. Hold the grille at a 45° angle, lift it up
slightly and detach it from the main body.
St ep 2: Inst all t he panel
Align the indicate "△" on the decoration
panel to the indicate "△" on the unit .
Attach the decoration panel to the unit with
the supplied screws as shown in gure below.
After installing the decoration panel, ensure
that there is no space between the unit body
and decoration panel. Otherwise air may leak
through the gap and cause dewdrop. (See
gure below)
Decoration panel
Screws (M5)
(supplied with
the panel)