Use; Connecting The Accessories; Safety Requirements During Use - Mectron starlight pro Manual De Uso Y Mantenimiento

starlight pro
6

USE

6.1

Connecting the Accessories

! WARNING: Check the condition of the device before the treatment. Before each
treatment, always make sure that the equipment is working properly and check the efficiency
of the accessories. If any improper functioning is noted, do not proceed with the treatment. If
the problem concerns the equipment contact an authorised technical assistance centre.
! WARNING: Infections control. For maximum safety of the patient and of the operator,
before each treatment, clean, disinfect and sterilise the optical fibre and the optical protection.
Carefully follow the instructions provided in
Before using the starlight pro proceed as follows:
1. Manually insert the optic fibre onto the handpiece, applying gentle pressure. If necessary,
rotate until it clicks into place (see Figure 7 at page 16);
2. Fit the optical protection onto the optical fibre by hand (see Figure 7 at page 16).
1
2
6.2 Safety Requirements During Use
! WARNING: Never point the beam of light in the direction of the eyes.
! WARNING: Before each cycle of exposure make sure that the optical fibre is correctly
and fully fitted into the handpiece.
! WARNING: Before each cycle of exposure always make sure that the optical
protection has been fitted onto the end of the optical fibre.
16
Chapter 7 on page 19
Figure 7 – Connecting the Accessories
.