Publicidad
3.
Installation
3.1 Appropriate installation
location
Contact an Authorized Service for
the installation of the product. In
order to prepare the product for use,
refer the information in the user
manual and ensure that electrical
installation and water installation are
appropriate. If not, call a qualified
electrician and technician to have
any necessary arrangements carried
out.
WARNING:
Manufacturer shall not be
B
held liable for damages
that may arise from
procedures carried out by
unauthorized persons.
WARNING:
must not be plugged
in during installation.
B
Otherwise, there is the
risk of death or serious
injury!
WARNING:
clearance of the room
where the product shall be
place is so tight to prevent
passing of the product,
A
remove the door of the
room and pass the product
through the door by
turning it to its side; if this
does not work, contact the
authorized service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as
hobs, heater cores and stoves and
at least 5 cm away from electrical
ovens.
• Product must not be subjected to
• Appropriate air ventilation must
• Do not install the product in places
•
•
Product
If the door
direct sun light and kept in humid
places.
be provided around your product
in order to achieve an efficient
operation. If the product is to be
placed in a recess in the wall, pay
attention to leave at least 5 cm
distance with the ceiling and side
walls.
where the temperature falls below
-5°C.
Your product requires adequate
air circulation to function
efficiently. If the product will be
placed in an alcove, remember
to leave at least 5 cm clearance
between the product and the
ceiling, rear wall and the side
walls.
If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between
the product and the ceiling,
rear wall and the side walls.
Check if the rear wall clearance
protection component is present
at its location (if provided with
the product). If the component
is not available, or if it is lost
or fallen, position the product
so that at least 5 cm clearance
shall be left between the rear
surface of the product and the
wall of the room. The clearance
at the rear is important for
efficient operation of the
product.
DA
SV
NO
FIN
EL
RO
NL
ES
BG
IT
PT
13
Publicidad
Solución de problemas
