Publicidad
Idiomas disponibles
Idiomas disponibles
1.
IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan
damage could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
3.
Remove the battery cover from remote control by
screwdriver and retain the screw for later. (Figure 3)
4.
To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting
process. If not used for long periods of time, remove
battery to prevent damage to transmitter. Store the
remote away from excessive heat or humidly.
(Figure 4)
WARNING
Chemical Burn Hazard. Keep batteries away from
children.
How to Operate Your Ceiling Fan
For illustrative purposes only-not
intended to cover all types of controls
3V CR2032
3V CR2032
Battery (2 pcs)
Battery (2 pcs)
15
Figure 1
MAIN FUSE BOX
Figure 2
Figure 3
Figure 4
Figure 4
Publicidad
