This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
(Not Included)
• One Phillips head screwdriver
• One 1/4˝ flat head screwdriver
• One hex wrench
• One stepladder
• One wire stripper • Four wire connectors
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 12). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
Do not install or use fan if any part is damaged or missing. This product is designed to use only those parts supplied with
this product and/or any accessories designated specifically for use with this product by Fanimation. Substitution of parts
or accessories not designated for use with this product by Fanimation could result in personal injury or property damage.
Contact your retail store for missing or damaged parts.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to exploded view illustration.
Hanger Bracket
Assembly (1)
Downrod/ Hanger Ball
Assembly (1)
– Downrod (1)
– Hanger Ball (1)
– Set Screw (1)
– Hairpin Clip (1)
– Clevis Pin (1)
– Pin (1)
Hardware Bags
3/16"-24 Serrated Head
Screws (10)
Unpacking Instructions
Canopy Screw
Cover Assembly (1)
Motor Coupling
Cover Assembly
Motor Assembly (1)
Flat Washers (10)
Wire Connectors (4)
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
WARNING
Ceiling Canopy (1)
(1)
Upper Housing (1)
Hand-held Remote (1)
Wall Holder (1)
Screws (2)
Batteries (2)
Safety Cable Kit
Safety Cable (1)
4
Materials
Wire Size A.W.G.
Up to 50 ft.
50 - 100 ft.
Receiver (1)
Wire Connectors (7)
Cable Clamp (1)
Flat Washer,
Stainless Steel
14
12
Blade Set (1)
Lag Bolt
(1)
(1)