Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove the hanger ball
downrod/hanger ball assembly by loosening the set
screw in the hanger ball until the ball falls freely
down the downrod. Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstal-lation in Step 6.
(Figure 1)
2.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Route
red, gray and yellow wires
through the downrod.
(Figure 3)
4. Slide downrod into the downrodsupport on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install and tighten
the two set screws with nuts in the downrod support.
(Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires and
safety cable
coupling cover, canopy screw cover and ceiling
canopy. (Figure 5)
How to Assemble Your Ceiling Fan
portion
from the
and safety cable
through motor
Downrod
Hanger Ball
Hairpin Clip
Downrod
Ceiling Canopy
Canopy Screw
Cover
8
Pin
Set Screw
Figure 1
Clevis Pin
Figure 2
Red, Gray, Yellow wires
and
Safety Cable
Figure 3
Set Screws and
Locking Nuts (2)
Clevis Pin
Hairpin Clip
Figure 4
Motor Coupling
Cover
Figure 5
Publicidad
