Publicidad
Idiomas disponibles
Idiomas disponibles
Settings
Printer
Remember Sample
Select region
M
Place
AR (Argentina)
AT (Österreich)
Reaction Time
AU (Australia)
BE (Belgique)
Lamp Settings
BE (België)
BG (БЪԓгариЯ)
NTU Check
Standard Measurement
Fig. 7: Predefined list
Seleccionar patrón
Select standard
0-04 Amonio 10 (REF 925 011)
0-04 Ammonium 10 (REF 925 011)
0-05 Ammonium 50 (REF 925 012)
0-05 Amonio 50 (REF 925 012)
0-06 Ammonium 200 (REF 925 013)
0-06 Amonio 200 (REF 925 013)
0-07 AOX 3 (REF 925 07)
0-07 AOX 3 (REF 925 07)
0-08 Amonio 100 (REF 925 013)
0-08 Ammonium 100 (REF 925 013)
0-09 Lead 5 (REF 925 016)
0-09 Plomb (REF 925 016)
Fig. 8: Dynamic list
Step 3: Perform test
Possible hazards upon contact with chemical and biological substances. Working
with samples, reagents, and the corresponding accessories is associated with
hazards.
When working with the cuvettes, it must be ensured that suitable protective equipment is
worn. Observe the safety data sheet (SDS) of the test kit used.
Clean all cuvettes before insertion using a lint‑free cloth to remove contamination or
moisture on the cuvette and prevent soiling of the cuvette shaft.
Quickstart Guide NANOCOLOR
12
Open Mode, 01.03.2016, 10:57
A new list entry can be created here by pressing
Sipper
in the upper right‑hand corner of the list.
+
A number pad or a keyboard appears to input
Backup
the new list entry. After successful input, the
new entry appears in the list. Deleting entries is
1:x
Dilution Format
1+x
possible only in dynamic lists. To delete an entry,
hold it down briefly. A trashcan icon appears. The
Power saving mode
list entry is deleted by pressing this icon.
Open Mode, 01.03.2016, 10:57
+
+
0.0
0.0
0.0
0.0
OK
OK
WARNING
NOTICE
/
II / VIS II V 2.00/09‑2022
® UV
VIS
J
Publicidad
