MACHEREY-NAGEL NANOCOLOR VIS II Guía Rápida página 7

Initial operation
Step 1: Power supply unit
Multiple hazards: Instructions in this step should be performed only by qualified staff.
Risk of electrical shock: Ensure that the power cable does not show any signs of
damage. Check the suitability of the voltage source used for the device.
Risk of injury because of tipping hazard due to slipping. Set up the device on an even
surface. Do not stack the device.
The device is designed for indoor and outdoor use. Do not expose the device to direct
sunlight. During use outdoors, protect the interfaces from exposure to humidity and
moisture.
Risk of fire: Ensure that the power outlet is not overloaded. There is a risk of overload
and fire. Ensure that the power cable does not show any signs of damage. Check the
suitability of the voltage source used for the device.
Risk of injury: Familiarize yourself with the device before working with it and read this
document carefully. Use the device only if you have been trained in how to handle it.
Defects to the power supply unit and the housing can lead to a malfunction of the device. If
the device has an obvious crack in the housing or a damaged power supply unit, the device
should be taken out of service.
Eye damage: The deuterium lamp of the NANOCOLOR
ultraviolet range which can damage eyes. Therefore, never look directly into the radiation
from this light source without suitable protective UV goggles. Also protect your skin from the
direct effect of UV light.
Risk of injury because of tipping hazard due to slipping. Set up the device on an even
surface. Do not stack the device.
Quickstart Guide NANOCOLOR
CAUTION
WARNING
CAUTION
NOTICE
WARNING
WARNING
NOTICE
WARNING
/
® UV
VIS
CAUTION
/ II / VIS II V 2.00/09‑2022
® UV
VIS
II generates radiation in the
7